gogllogo.blogg.se - Skyrocket nano drone

Batteries are to be inserted using correct polarity.

Different types of batteries or new and old batteries are not to be mixed.

Check your local laws and regulations for correct recycling They should not beĭisposed of with other household waste. LiPo Battery Disposal: LiPo batteries must be recycled or disposed of properly.

Use caution to avoid puncture of the battery.

Never store or charge battery inside the car in extreme temperatures, since extreme temperature could.

Disconnect with the charging wire if the battery is fully charged.

When charging battery you should always remain in constant observation to monitor the charging process and react to potential problems that may occur.

Do not stress, press or drop the battery.

Do not leave battery connected to drone when not in use.

Never throw battery in a fire or attempt to open outer casing.

The supply terminals are not to be short circuited.

Remove battery from the compartment if toy is not used for a long period of time.Remove exhausted battery as soon as possible and discard properly.Do not drop or make subject to strong impact.Do not place in fire or leave in hot places.The LiPo battery is only to be used with the drone and charger included with this product. Read all following precautions and instructions regarding the care and use

LiPo batteries have a severe risk of fire and injury if they are improperly handled or misused. THIS PRODUCT CONTAINS A LITHIUM-POLYMER BATTERY 3.7V 100mAh: Never leave drone unattended while it is turned on. Keep spinning rotors away from fingers, hair, eyes and other body parts. Discontinue operation immediately if drone flies out of your field of view. NeverĪttempt to retrieve drone from any location higher than your reach (such as rooftops or trees) or fromĪny location that poses a safety hazard. Keep a safe distance away from streets, public thoroughfares and power lines. Avoid flying near interior fans and/or vents as they may make flyingĭifficult to control. Responsible for any actions that result in damage or injury from the improper operation of drone.Īdequate flying space is required. Drone has rotating blades that move at high speed, posing danger of damage and injury. When the controller is OFF, press and holdīutton, and POWER button for three secondsīefore each use, an adult should check this product and the LiPo battery to ensure no damage or hazardsĮxist. Several times until the drone stops spinning. IF THE DRONE SPINS COUNTER-CLOCKWISE (VIEWED FROM ABOVE): Press theīutton several times until the drone stops Do not use excessiveįorce when putting the propeller on the motor.Ĭontroller, it will automatically land itself Tweezers, clear debris, and then replace the propeller. If one or more of your drone's propellers will not spin, check for foreign objects The drone should be flying at least 6 feet in the air with a minimum clearance of 6 feet in all directions before Remove finger from the RIGHT thumbstick.Ģ While hovering, press and hold the STUNT button.ģ Then quickly tap the RIGHT thumbstick in the direction Reached the ground, and the motors will stop spinning.ġ Bring the drone to a mid-air hover without flying in anyĭirection. Hold the left thumbstick all the way downįor about 2.5 seconds after the drone has safely While flying forward (or reverse), tap the STUNT button.Īlternatively you can use the left thumbstick to land Once a stunt has been initiated, DO NOT adjust Throttle or press any other controls until the stunt has been completed. Use RIGHT (Directional) thumbstick to fly forward, Move both thumbsticks down and away from the center of the controller. If for any reason you need to immediately stop the drone, hold down the stuntīutton (for drones that don't have a stunt button, use the video button) and Higher or lower and left or right to rotate. Move LEFT (Throttle) thumbstick up or down to make drone fly

Press LAUNCH to automatically launch a few feet off the ground. Should be facing the same way the drone is facing. With the drone facing away from you (green blades forward). To make flying easier, place the drone on the ground in front of you When LEDs turn solid, the drone is ready to fly.